setting_up_the_game
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
setting_up_the_game [2017/06/24 21:36] lurk [Replace files] |
setting_up_the_game [2017/08/07 15:37] lurk [Get the files] |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| engine.dll // hexedited to fix less than 15mb issue | engine.dll // hexedited to fix less than 15mb issue | ||
| shaderapidx9.dll // hexedited to fix low detail | shaderapidx9.dll // hexedited to fix low detail | ||
| - | unofficialengine.dll // from the Unofficial Patch</ | + | vampire.dll // from the Unofficial Patch</ |
| ===== Install the game ===== | ===== Install the game ===== | ||
| Line 35: | Line 35: | ||
| Finally, Microsoft turned off the secdrv service because of security exploits. Unfortunately, | Finally, Microsoft turned off the secdrv service because of security exploits. Unfortunately, | ||
| + | So, replace: | ||
| + | < | ||
| + | ..\Activision\Vampire - Bloodlines\vampire.exe | ||
| + | ..\Activision\Vampire - Bloodlines\Bin\engine.dll | ||
| + | ..\Activision\Vampire - Bloodlines\Bin\shaderapidx9.dll | ||
| + | ..\Activision\Vampire - Bloodlines\Vampire\cfg | ||
| + | </ | ||
| ===== Run the game and watch the intro ===== | ===== Run the game and watch the intro ===== | ||
| - | Run the game and make sure it works. You have to watch the introduction cutscene at least once before you can get the skip intro button. | + | Run the game and make sure it works. You have to watch the introduction cutscene at least once before you can get the skip intro button. You can usually use the console command // |
| ===== Setup game configuration files ===== | ===== Setup game configuration files ===== | ||
setting_up_the_game.txt ยท Last modified: 2017/08/07 15:37 by lurk
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
